Had to decide on what to use for floorboards. I should have planned out the floor placements based upon the length of available stock. Alas, what I had planned to use was just on the short side. Long enough, but just. Luckily, I had some other stock that was longer, and nicer, too.

It took awhile to plan out how to lay out the floorboards for best fit, etc. It took quite awhile, too, to cut and mill it. Imagine holding a 2" x 3", 15 foot long piece of Fir and feeding it into the bandsaw cutting off very precise 1/2" thick slices. I had no room for error and the long end sticking out from the saw is awkward and heavy!

I had to adjust the floors, too, to get everything to lay our just right. While I was at it, I adjusted my floor patterns so next time this will all go easier. I took notes of the floorboard dimensions for the same reason.